$48.00
Description
5″ Shrinking Disc and Backing Pad
5″ Shrinking Disc (Stainless Steel)
This is the original smooth and safe edge shrinking disc
•Use this five inch diameter shrinking disc on confined surface areas that are not accessible with my larger 9″ dia. shrinking discs.
•This smaller disc should not be used as a substitute for my nine inch shrinking disc.
•I use my shrinking discs on every panel I make ( aluminum and steel) to super smooth the surface. Any panel when finished whether new or repaired is left ready for primer ( bondo filler free).
•I teach how to properly use my shrinking discs at all of my sheetmetal shaping classes.
•Mount with standard 7/8″ dia. ( 5/8 x 11 thread) autobody grinder flange nut. To mount to a different thread or grinder stud size you will have to adapt a bushing or collar( very easy to do) I sell these all over the world.
•Made from 16 gage stainless, this tool will last for many years.
5” Backing Pad and 5/8″ x 11 threaded plate
This backing pad and threaded plate should only be used for the 5″ Shrinking Disc.
•I teach how to properly use my shrinking discs at all of my sheetmetal shaping classes.
•Mount with standard 7/8″ dia. ( 5/8 x 11 thread) autobody grinder flange nut. To mount to a different thread or grinder stud size you will have to adapt a bushing or collar( very easy to do) I sell these all over the world.
How to install your 5′ Shrinking Disc
Place the 2 washers on first
Put the backing pad on top of the washers
Place the shrinking disc with the rounded edge up
Screw on the flange neck nut (Make sure the nut and spindle are both below the working surface)
